Friday, April 3, 2009

Reset MP390 Waste Ink Full Tank



The below reset procedure worked for me. I did not have to clean the waste-ink sponge. Many thanks to lp who originally posted it and to "Anonymous" who reposted it.

1)Printer on, press Additional Functions, Scan, Copy, Scan
Now you should be in service mode from there for waste ink tank reset

2)Select Test mode which is like the last avalabe selection
3)Select #8 Printer Test, it will do something here like cleaning or something then it will come up with some other option this is where it gets a bit confusing cause now all it says is like 8-2 or 8-3 push the + or - button until it says 8-3 then hit the select button

The menu will now say EEPRON Clear
Select Ink count which is option (0) and press set

Then press Stop/Reset Followed by the power button and then wait for it to restart.

iP Tool : Download
EEPROM Printer Canon ip6210D/6220D/MP170/MP450/2200/ip600 Download
MPTool MP150/MP160/MP170/MP180/MP450/MP460 Download
Step By Step Resetter canon MP Download

Reseter Printer Canon IP1880

To reset manually Ink Full Tank, try these methods :
1. Turn on Printer Canon iP 1880
2. Push and Hold resume button about 2 minutes
3. Release resume button
4. Printer will back in normal again
5. Then use the software.
6. Good Luck friend
7. If you want this permanent, Please Download Reset Tool

8. Reset tool support Canon iP2500, iP 1800, iP 1100

Download step by step canon iR1880, iP1980
Don’t forget your comment in guest book.

Adjustment Program for Stylus C40UX ,C40SX, C20UX, C20SX Operating Instructions

Tags

1. Operating Environment:
l Windows95 OSR2.0 or higher and Windows98.
l (for Windows95)
LPT1-LPT3 are used.
(for Windows98)
LPT1-LPT3 and EPUSB1-EPUSB3 are used.
2. How to use the Adjustment Program:
Copy the Adjustment Program on the desktop, and then , execute the program.
3. Cautions:
1) When you confirm the function of USB port properly, you must use Windows98
pre-installed PC. It cannot function properly on Windows95.
2) When you operate this program on the Windows95 or Windows98, you cannot
operate it with Status Monitor is running. Close Status Monitor on Task tray
before start the Adjustment Program.
3) Do not change the setting for “Font size” in “settings tab” of the
“Display Property”window.
4) Please do not start the Adjustment Program before connecting the printer with
a parallel I/F cable or USB I/F cable.
If you do not follow the instruction, the program will freeze.
5) Please do not send any commands during Check Pattern printing.
6) In case of turning off the printer, or the parallel I/F cable or USB I/F
cable is removed during booting the Adjustment Program, please restart the Adjustment Program.

Adjustment Program for Stylus C40UX / C40SX / C20UX / C20SX : Download
Adjustment Program for Stylus C61/C62: Download