The fixing temperature does not go up after turning ON the power
due to a fault in the thermistor or the heater, etc., (e.g. It does not
reach 70°C degrees within 2 min.)
The fixing temperature abnormally goes up due to a fault in the
thermistor or SSR, etc.
The fixing temperature does not reach a specific temperature due
to a fault in the thermistor or the heater, etc.
e.g) The fixing temperature does not go up to 190°C degrees
within 5 min after reaching 70°C degrees.
The fixing temperature drops abnormally after wait time is up due
to a fault in the thermistor, the heater, etc. (e.g. After wait time is
up, the fixing temperature drops to 70°C degrees).
A short circuit in the fixing heater drive circuit (SSR, etc) is
E005 The fixing web is wound up completely.
E006 The fixing drawer connector is not connected as the front door is closed.
E007 The fixing film is off to the side.
A specific number of copies are made after the machine detects
that fixing oil is out.
E009 The rated voltages of the power supply and the fixing unit do not
E010 Clock pulses fail to be generated or the PLL lock fails to be
released due to a fault in the main motor unit
E011 Excess current flows to the motor control circuit because the main
Clock pulses fail to be generated or the PLL lock is released due to
a fault in the drum motor, etc.
Friday, February 20, 2004