Sunday, April 26, 2009

reset waste ink canon iP4000

Here this step by step to resetting waste ink counter printer canon iP4000
1. With the printer plugged in and powered off, press and hold the
Resume/Cancel button, then press and hold the Power button.
Do not release the buttons. The LED light should be green to
indicate that a function is selectable
2. While holding the Power button, release the Resume/Cancel button,
do not release the Power button
3. While holding the Power button, press the Resume/Cancel button 2 times,
and then release both the Power and Resume/Cancel buttons. Each time the
Resume/Cancel button is pressed, the LED lights alternately in orange and
green, starting with orange.
4. When the LED light is green, press the Resume/Cancel button 4 times. Each
time the Resume/Cancel button is pressed, the LED lights alternately in
orange and green, starting with orange.
5. Press the Power button. The LED lights in green, and the reset is performed.
When the operation completes, the printer returns to the menu selection
mode automatically
6. Press the power button to exit service mode.

6 comments:

Anonymous said...

Reset Waste Ink Printer Canon 'S' Series
Here this step to reset waste ink printer canon "S" series
1. Turn off the printer.
2. Press and hold the RESUME button, then press and hold the POWER button.
3. Release the RESUME button, Next press and release the RESUME button
two(2) more times in succession. Note: you are still holding the POWER
button). The printer’s carriage will “reset” or move momentarily. If the above
was properly performed the printer will enter the “Service Mode”.
4. Press the RESUME button 4 times, this will select the clear waste ink counter
function. The lamp will alternate (change) color with each key press.
After selecting the desired mode (eg 4), press the POWER button to “set” the
change, and return to the top of the function selection menu. Press the POWER
button again to restart the printer.

Anonymous said...

thanks friend , resetter canon

Anonymous said...

iP3000 power supply K30233 only has three wires.
Measure voltage with power supply pulled out of printer but with 3-wire plug still plugged up. Printers logic board turns power supply 8 volts stand by to 24 volts run voltage.



Pin 1 red wire = 8 volts dc printer off and 24 volts DC printer on.
Pin 2 black wire = printer ground
Pin 3 yellow wire = 0 volts dc printer off and 3.1 volts dc printer on.

Anonymous said...

Pixma IP3000
1. Turn off printer.
2. retaining button Resume/Cancel press button POWER - indicator it will catch fire by green color.
3. let go button Resume/Cancel, continuing to retain POWER.
4. press button Resume/Cancel of 2 times, retaining POWER, after which let go all buttons.
5. when indicator will be lit BY GREEN - press button Resume/Cancel of 4 times!!!
6. turn off printer by button POWER.
It is undertaken from service manuala.

Anonymous said...

Pixma IP3000
1. Turn off printer.
2. retaining button Resume/Cancel press button POWER - indicator it will catch fire by green color.
3. let go button Resume/Cancel, continuing to retain POWER.
4. press button Resume/Cancel of 2 times, retaining POWER, after which let go all buttons.
5. when indicator will be lit BY GREEN - press button Resume/Cancel of 4 times!!!
6. turn off printer by button POWER.
It is undertaken from service manuala.

Don said...

Anybody have canon IP4970 resetter?