loading...

Wednesday, February 4, 2009

REFILL CARTRIDGE 41

If you don't understand the method to fill catridge refill 41, try this method ;



Give your comment in guest book and hope it help you friend

1 comment:

Anonymous said...

I had the same problem...
I tried everything posted here and other forums with no succes..
Until I found a solution for Canon MP-160:

MP-160 is different from MX300 so I tried my best with it...
The main solution is to reset the entire printer:
1. Disconnect the power cable
2. Connect it while holding down the power button
3. With the power button still down, press twice the "Cancel/Stop" red button
4. Release the power button
5. The printes turns into a kind of factory mode...(wait for about 10 seconds, utils it says "Idle")
6. Press the ">" (next to the "OK" button) once."Shipping Mode 3"
7. Press the "OK" button.
8. Press "OK" again for "Without cleaning"
9. A test page will print..
10. Open the cover, like you are about to change the cartridges.
11. Disconnect the power cable again.
12. Take out both cartridges.
13. Close the cover.
14. Connect the power cable once again.
15. Turn the printer on.
16. Now just put the cartridges back...

It works right for me...