loading...

Tuesday, January 20, 2009

Reset CANON PG40 PG41 ink counter cartrige


Try this
Dowload

Power off printer
Hold down STOP/RESET button then Press and Hold down Power button
Keep Power button down and Release STOP/RESET button
Push STOP/RESET button twice
Wait 20-30 seconds - our LED showed Idle
Push STOP/RESET button four times
Push Power button twice
Power off
Next time the printer is started the waste count will have been reset

5 comments:

Anonymous said...

Help me Resetter canon send email skl@yahoo.com

Anonymous said...

I have had good luck refilling my Canon iP1800 40 & 41 ink cartridges.
I have not been able to reset the Ink Counter....but I have a "work around" that is quite satisfactory.
I can tell when I am low on ink so the counter is really unnecessary.
After refilling the cartridges and cleaning the bottom where the ink is dispensed I replace the cartridges and hold down the "reset" button for approx. 10 seconds. The reset button being the lower of the two buttons.
Occasionally I find that the black ink (even when I know it is full) will not print. I remove the unit and clean the bottom again. That seems to fix the problem.
I don't mind fussing with these cartridges since I save so much money doing my own refills.
Hope this is helpful to you.

Anonymous said...

Power off printer
Hold down STOP/RESET button then Press and Hold down Power button
Keep Power button down and Release STOP/RESET button
Release power button
Push STOP/RESET button twice
Wait 20-30 seconds - our LED showed Idle
Push STOP/RESET button four times
Push Power button twice
Power off
Next time the printer is started the waste count will have been reset

Anonymous said...

Questa procedura vale per la 1600,prova anche sulla tua.
1. Togli il cavo d'alimentazione.
2. Tenendo premuto il tasto ON inserisci il cavo d'alimentazione.
3 Sempre tenendo premuto il pulsante ON premi 2 volte il
tasto presa carta.
4.rilascia tutto.

mariolink

Anonymous said...

this is what i had to do to get it to work with canon mp460


1. Disconnect the power cable
2. Hold down power button
3. Reconnect the power cable
4. With the power button still down, press twice the “Cancel/Stop” red button
5. Release the power button
6. The printer is now in factory mode...(wait about 30 seconds until it says “idle”)
7. Press the down arrow (next to the “OK” button) until it says “Shipping Mode 1”
8. Press the “OK” Button
9. Now with it displaying “Without Cleaning” press the power button
10. A test page should print
11. Now open cover
12. Disconnect the power again
13. Take both cartridges out like normal
14. Close cover
15. Reconnect power cable
16. Press power button
17. Replace cartridges