loading...

Friday, January 11, 2008

resetter canon i320 i255

Waste Ink Counter Reset.
Step Manual Temporary
1. Unplug power and USB.
2. Open door and hold power button.
3. Connect power.
4. Close door, then release power button.

or

Step 1: Manual Temporary
1. Turn off the printer. And disconnect the printer cable.
2. Press and hold the POWER button, turn on the printer.
3. The indicator (L.E.D.) should be green.
4. Press and release the RESUME button , the indicator (L.E.D.) should be orange.
5. Press and release the RESUME button again, the indicator (L.E.D.) should be green.
6. Release both buttons.

step 2 : Software for Permanant
1. Reconnect the printer cable.
2.Open General Tools software and select (USB PORT)
3.Choose (SET DESTINATION 1) And it should be reset.

Sofware Download "After service mode Pls use software for permanent reset"

4 comments:

Anonymous said...

thanks alot sangon.
it's work !!!! great.
may be step 1 is "unplug AC outlet"
thanks very much. my i255 is run again.

but, can i use that advice for canon i70 ?

Anonymous said...

it taken from service manual canon i455

1. Switch off the printer.
2. Keeping button Resume/Cancel press button POWER - the indicator will light up green color.
3. Release(Let off) button Resume/Cancel, continuing to keep POWER.
4. Press button Resume/Cancel 2 times, keeping POWER then release(let off) all buttons.
5. When the indicator will be lighted GREEN - press button Resume/Cancel 4 times!!!
6. Switch off the printer button POWER.

Anonymous said...

Thank you Anonymous

This reset worked great: (I did substitute unplug for step 1 and plug in for the second part of step two). Printer is working again!

i320 waste ink counter reset.
1. Turn off the printer.
2. Press and hold the POWER button, turn on the printer.
3. The indicator should be green.
3. Press and release the RESUME button , the indicator should be orange.
4. Press and release the RESUME button again, the indicator should be green.
5. Release both buttons.
6.Connect the printer to PC.
7.Open General Tool software,choose ¡°USB PORT¡±.
8.Choose ¡°SET DESTINATION 1 ¡±,OK!

Anonymous said...

Thank you very much for your solution.